|
當前位置： 產品介紹 — 海德利森（Hydrosys）液體增壓泵
| |
Haskel氣動液壓泵
最高工作壓力可達到690Mpa； 輸出流量大，只需100psi（0.69Mpa）壓縮空氣驅動就可獲得較大的輸出流量。
|
| 壓縮介質(Service Code) |
- Petroleum base oils, Kerosene, Diesel fuel, with 5% soluble oil.
- Plain Water.
- Most phosphate Ester base fire resistant hydraulic fluids:e.g., Pydraul, Lindol, Cellulube, Fyrquel, and Houghtosate 1120 and Petroleum base solvents compatible with UHMWPE (Ultrahigh Molecular Weight Polyethylene) dynamic, and Viton static seals.
- Petroleum base solvents,e.g., Boron fuels, Aromatic hydrocarbons( Benzene ,Toluene Xylene, Hylene, etc.);Chlorinated solvents (Trichloroethylene, Carbon Tetrachloride,? Chlorobenzene ,etc.); Mecaptans, Dowtherm A, Fluoronated solents(Fluorobenzene, Fluorochloroethylene ,etc.); Dowtherm E, plus all of group 3 plus some mildly corrosive acids compatible with wetted materials.
See note (5A) for service with Methyl-Ethy-Ketone, Methyl Acetone, Diacetone, Alcohol and Freon 22
-
Skydrol and Aerosafe hydraulic fluid. Acetone and some alcohols (Ethy, Methy and isopropyl).Also suitable for these fluid if viton static seals replaced with EPR, specify modification number 51331(no extra change),e.g..5133-MDTV-5.(Most Phosphate Estar base fluids solidify at approximately 206 MPa .)
- Deionized water.
NOTE: a) Dynamic seal life with non-lubricating fluids will understandably be less than with lubricating type.
b) Consult factory for additional chemical resistance data.
|
|
HASKEL 1/3HP PUMP 【1/3馬力（0.25Kw）haskel液體增壓泵系列】
| 型號 |
序號 |
壓縮比
（增壓比） |
最高輸出壓力 |
排量/循環 |
| MODEL |
RATIO DASH NO. |
ACTUAL AREA RATIO |
MAXIMUM RATED OUTPUT PRESSURE |
DISPLACE
MENT
/CYCLE |
CONTINUOUS
(連續輸出)MPa |
INTERMITTENT
（間歇輸出）MPa |
| M,MDTV,MDSTV |
-5 |
-5.6 |
4.3 |
4.3 |
0.83 |
13.6 |
| M, MS |
-7 |
7.8 |
6.2 |
6.2 |
0.60 |
9.8 |
-12 |
14 |
10.3 |
10.3 |
0.36 |
5.9 |
M,MS,MCPV,
29723 (1) |
-21 |
25 |
17.9 |
17.9 |
0.20 |
3.3 |
-36 |
41 |
31 |
31 |
0.12 |
2.0 |
-71 |
82 |
60.7 |
60.7 |
.060 |
1.0 |
-110 |
126 |
93.1 |
93.1 |
.039 |
0.6 |
| M, MS (1) |
-188 |
217 |
103.4 |
103.4 |
.023 |
0.4 |
1.Maximum intermittent pressure for stainless steel in MS, 29723 and MCPV series pumps is 69MPa
2. 最高驅動氣壓力0.85MPa( Maximum drive pressure0.85MPa)
| 型號 |
服務介質 |
材質 |
非金屬材質 |
| MODE |
SERVICES |
WETTED MATERIALS |
NON METALLICS |
泵部分
PUMP SECTION |
活塞部分
PLUNGERS |
| M |
[1] |
Cad plated steel,luminum & SS |
416 SS |
Urethane, PTEF,Buna |
| MS |
[1][2] |
All SS |
316 SS |
UHMWPE, PTEE, Buna |
| MDTV |
[1][3][5] |
Separtion-Aluminum & SS |
416 SS |
PTFE, Viton |
| MDSTV |
[1][2][3][4][5] |
Separtion - All SS |
416 SS |
PTFE, Viton |
| MCPV |
[1][2][3][4][5] |
Separtion - All SS |
15.5PH SS |
PTFE, Viton |
| 29723 |
[1][2][3][5][6] |
Separtion - All SS |
Hard Chrome Plated 15.5PH SS + Dichronite |
UHMWPE, PTFE, Ryton |
|
|
